Skip to main content

Table 1 Composition and lot number of the materials used

From: Effects of ceramic primers and post-silanization heat treatment on bond strength of resin cement to lithium disilicate-based ceramic

Materials used Composition (lot number) Application technique
Clearfil Ceramic Primer Ethanol, 10-methacryloyloxydecyl dihydrogen phosphate, 3-methacryloyloxypropyl-trimethoxysilane (00002B) 1. Apply Clearfil Ceramic Primer
2. Dry ceramic surface by blowing mild oil-free air
MonoBond-S Ethanol, water, 3-methacriloiloxipropil-trimetoxisilane (K25651) 1. Apply Monobond-S with microbrush
2. Allow the material to react for 60 s
3. Disperse with a strong stream of air
ProSil Ethanol, water, 3-methacryloyloxypropyl-trimethoxysilane (250108) 1. Apply ProSil with microbrush
2. Allow the material to react for 60 s
3. Dry ceramic surface by blowing mild oil-free air
RelyX Ceramic Primer Ethanol, water, 3-methacryloxypropyl-trimethoxysilane (7YF) 1. Apply RelyX Ceramic Primer to the internal (etched) surfaces
2. Gently blow oil-free air across the surface or allow the solvent to evaporate completely
Silano Ethanol, glacial acetic acid, silane (769868) 1. Place one drop of Silane Primer and Silane Activator into the mixing well
2. Mix thoroughly for 10–15 min
3. Leave the mixture for 5 min
4. Apply Silane mixture and air-dry by blowing
5. Apply the second layer and air-dry by blowing
RelyX CRA BisGMA, TEGDMA, dimethacrylate polymer, amine, photoinitiator system, benzoyl peroxide, pigments, zirconia/silica fillers (67.5% by weight and 1.5 μm average particle size) (GEHG) 1. Dispense paste A and B of cement onto a mixing pad and mix for 10 s
2. Light cured for 40 s